Construction Machine Blog

1, Impact Crusher can effectively handle the large amount of moisture content of materials, to prevent the blockage of the phenomenon of Crusher
In dealing with excessive moisture content of materials, the counter-attack crusher feed chute and the back plate can be equipped with heating devices to prevent the bonding material. Impact Crusher is equipped with the bottom of the sieve plate do not need to be effective in preventing clogging phenomenon. The hammer crusher can not be used to prevent heating of the bonding material, and shall be equipped with the bottom of the sieve plate, increasing the possibility of clogging.
2, back-breaking not only for soft materials also applies to very large hardness of materials
Hammer Crusher board mechanical clamping structure firmly set at the rotor, when the rotor rotates, with the great moment of inertia. Relative to the hammer crusher (hammer was hanging state), back-breaking of the rotor has a greater momentum, crushing harder to adapt to the material, were also lower power consumption.
3, Impact Crusher can be easily adjustable and flexible discharge particle size, a wide range of adjustment
Impact Crusher can be adjusted through a variety of ways out of material particle size, such as the regulation of rotor speed, adjustable back plate and grinding chamber gap and so on. Gap adjustment can be mechanical or hydraulic adjustable, hydraulic-conditioning systems can be easily adopted by local operating buttons or remote controls system to complete the space adjustments. The hammer crusher discharge size adjustment can only be achieved by replacing the bottom of the sieve plate.
4, Impact Crusher wear wearing parts than the hammer crusher is small, high utilization rate of metal
Hammer Crusher wear plate only appears in the Looking material side. When the rotor speed is normal, the feed will drop to the board hammer surface (of attack), hammer on the back and side panels are not being worn. Even Looking material this side of the wear and tear would be minimal. And the bottom of the grinding rod is also very easy to replace. Back-breaking hammer the metal plate up to 45% utilization rate of -48%. The hammer crusher hammer was hanging condition, wear and tear occurred, the front and rear and side, relative to the plate hammer, hammer wear and tear is more serious, hammer metal utilization ratio is only about 25%. And the rotor body itself may be subject to wear and tear. Hammer crusher wear seriously affected by the bottom of the sieve-plate, grille should all replace, and replace the sieve of the work more complicated.
5, Impact Crusher spare parts replacement is simple, a corresponding reduction in maintenance costs
Broken rotor only counter to install six panel hammer, special tools can be easily board hammer replacement, the replacement of a board of only one frequency hammer time. The bottom of the grinding chamber grinding rod replacement also requires only several minutes, greatly reducing the repair and maintenance time and costs. The hammer crusher hammer up to more than 100, with the replacement of a hammer to spend a lot of time and manpower, repair and maintenance costs higher. The bottom of the screen plate and its replacement is also troublesome.

This entry was posted on Monday, December 28th, 2009 at 2:44 am and is filed under Crusher. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.